INSTALLATION PROCEDURE:
Allow panels to adjust to room temperatures (65º to 90º) for at least 6 hours.
Turn off hot and cold water supply, remove faucet handles, escutcheons, filler spouts and any fittings mounted to the wall that will be covered i.e. towel bars,
soap dishes, etc.
Use hammer and chisel to remove objects cemented to walls. Old ceramic tiles, if solidly adhered to walls, may be covered with this kit and need not be removed.
Loose ceramic tiles must be removed and sub walls sanded smooth.
Front edge ceramic tiles may be reset for appearance only. See “wall surface preparation recommendations” on previous page..
READ ALL INSTALLATION INSTRUCTIONS BEFORE STARTING. TRIAL FIT PANELS PRIOR TO FINAL INSTALLATION.
1. Corner Panels
If the tub has settled, or walls are out
of plumb, it may be necessary to file
the bottom edge of a given panel to
achieve a good fit across the top.
Select either left or right corner panel
(to identify the TW-32 right or left,
place the soap dish against the back
wall). Apply pressure sensitive tape
and the adhesive to the back of the
panel, keeping the adhesive at least
one inch from the tape and panel
edges.
2. Corner Panels (cont.)
For final fit, remove the backing from
the pressure sensitive tape and careful-
ly position corner panel. Press firmly
to wall…moving hand pressure up and
down and side to side, making sure all
areas make firm contact to wall.
Repeat steps 1 and 2 for installation of
the other corner panel.
3. Back Panel
Back panel is slightly taller than the
two corner panels, allowing for overlap
of the top edge. Trial fit, then apply
pressure sensitive tape and adhesive
following pattern in illustration and
add an extra circle around soap dish.
NOTE:
Depending on the condition of the
existing wall surface, additional adhe-
sive may be required to ensure contact
between the substrate and the wall
panel.
WINDOW TRIM KIT
Model WTK-1
(not part of TW-32 or WW-6000 TUB WALL KIT – available
through your dealer) This high-gloss Window Trim Kit is
designed to eliminate unsightly sills, decorate and make
waterproof the left and right jambs, plus provide a water-
proof-natural draining sill.
4. Back Panel (cont.)
Remove the backing from the pressure
sensitive tape and carefully center
panel with the bottom edge resting on
the top edge of the tub. Firmly press
the entire panel from top to bottom,
making sure of a solid contact.
Accessories
3
(16 paginas)
(4 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales